Date : 4 December, 2014
BAUER Advertisement in PLASTISCOPE October 2014 Edition
Gas assisted moulding involves the introduction of nitrogen under pressure to the mould cavity at a set time during the moulding cycle. The aim is to either hollow out thick section mouldings or eliminate sinkage and/or warpage in thin section injection mouldings. Gas injection can also result in stronger parts due to the 'box section' effect.
Recent Blogs
Anticipating Budget 2024: Insights from Industry Expert Mr. Ramesh...
22 July, 2024
22 July, 2024
SPE India Presents The Plastic Pipes Conference 2024 | shaping the...
19 April, 2024
19 April, 2024
Plastic Pipe 2024: Insights from SPE India Leaders
3 April, 2024
3 April, 2024
Ramesh Parasuraman’s Inspiring Welcome Address at SPE India Plas...
29 March, 2024
29 March, 2024
Must-See Highlights from SPE India's Plastic Pipes 2024 Event
22 March, 2024
22 March, 2024
SPE India President Shares Expectations for Budget 2024
31 January, 2024
31 January, 2024
Fireside Chat: Value Chain Collaboration-Plastic Circular Economy ...
27 February, 2023
27 February, 2023
SPE India President Speaks On Budget 2023
25 January, 2023
25 January, 2023
Mr. Ramesh Parasuraman, President Elect, SPE India at the RACE 3 C...
22 October, 2022
22 October, 2022
Welcome Remarks by Mr. Ramesh Parasuraman, President- SPE India - ...
2 August, 2021
2 August, 2021